Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2014 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Replacing 240 Drive Shaft Flex Joint (Guibo) 200

posted by  pageda on  Wed Mar 23 18:06 CST 2016
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 13:18 CST 2014
[RELATED]

Thanks Kitcat, I may give it a try tomorrow. More complicated than I first thought but probably not bad, My first and probably only flex joint

So there are 2 lengths for each set of 3 bolts that attack the flex joint? Trans side uses longer bolts?

I will put all the molded on markings of the joint forward as the original.

Not sure I understand the clocking of the joint? It seems like there are 3 ways to do this and I can't see where on is better than the other? I guess the best way to do this is to mark the old flex joint along with both flanges and transfer the mark on the old joint to the new one.

Thanks
Dan





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 Replacing 240 Drive Shaft Flex Joint (Guibo) [200]
posted by  pageda  on Wed Mar 23 05:15 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.