Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2018 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Replacing 240 Drive Shaft Flex Joint (Guibo) 200

posted by  TONY H on  Thu Mar 24 11:06 CST 2016
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 16:39 CST 2014
[RELATED]

As Dave stated. Center Support bearing is locked onto the forward shaft. When I replaced mine, i had the Shaft out so not an issue. I'd probably put a floor jack under the Center Support Bearing, Pull the two bolts and lower it a bit. It wont take too much lowering before you can slide the old one down and out and the new one up and in. Gotta be easier then dropping the Trani Cross Member. Universal type Sockets help a lot when disconnecting the coupler. Not much room for a socket with a Universal attached.
--
'75 Jeep CJ5 345Hp ChevyPwrd, two motorcycles, '85 Pickup: The '89 Volvo is the newest vehicle I own. it wasn't Volvos safety , it was Longevity that sold me http://home.lyse.net/brox/TonyPage4.html http://cleanflametrap.com/tony/






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 Replacing 240 Drive Shaft Flex Joint (Guibo) [200]
posted by  pageda  on Wed Mar 23 05:15 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.