Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Replacing 240 Drive Shaft Flex Joint (Giubo) - lift the 240/740 aft end to free rear wheels, to spin the drive shaft? 200

posted by  pageda on  Sat Mar 26 17:21 CST 2016
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 13:18 CST 2014
[RELATED]

I have a hard enough time with spell check but it won't touch this word! I think I will just call it a flex joint from now on!

I want to do this job without removing the exhaust system and the trans cross member. After spending a while on my back studying and trying various tools I think I can do it by just lowering the center driveshaft support and placing it on a jack stand.

I may need to let the rear wheels hang but at a minimum I need to be able rotate the shaft to loosen all the bolts.

The big problem is access to the front facing nuts and bolts with the trans cross member attached, I think I can use a large breaker bar and socket and rotate the shaft to get to each nut or bolt. On the rear facing nuts and bolts almost anything will work.

We will see!!!
Dan






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 Replacing 240 Drive Shaft Flex Joint (Guibo) [200]
posted by  pageda  on Wed Mar 23 05:15 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.