Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2021 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Replacing 240 Drive Shaft Flex Joint (Guibo) 200

I replace the flex joint this morning while the temps were in the low 60's. It took about an hour and a half from set up to clean up. I was able to replace it with removing the center drive shaft support bracket and resting the shaft of a jack stand. I had to lower the shaft a bit and push it off the the side to gain clearance to remove and replace the joint.

The old joint may have been a replacement from before I got the car as a couple of the bolts were swapped from the front side to the rear side. There are two different bolt lengths, the shorter bolts go from the front to the rear.

Not a bad job at all
Dan








THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 Replacing 240 Drive Shaft Flex Joint (Guibo) [200]
posted by  pageda  on Wed Mar 23 05:15 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.