Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 11/2000 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

in-tank pre-pump mounting? 200 1989

posted by  Art Benstein on  Tue Jan 28 07:41 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 20:10 CST 2014
[RELATED]

It seems to me kinda unfair you didn't get that bracket. Can't advise you to remove it from the old pump because your old one is most likely the VDO. It is different between the VDO pump and the AC Delco pump (ScanTech?). That happened to me too, but as my supplier was the pick and pull I had no one important to complain to. Not advice, here, but I felt somewhat confident letting it hang from the pipe; the fuel line I used seemed to be very firmly attached without clamps. Been about 10K of daily driving now... I have some drawings from the green manuals and perhaps a photo or two if you're wondering what that bracket looks like.
--
Art Benstein near Baltimore






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New in-tank pre-pump mounting? [200][1989]
posted by  greg_mustang  on Tue Jan 28 01:32 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.