Quantcast
V8 - Upper front strut mount/bearing assy; prefernces?

Volvo V8 Forum

INDEX FOR 12/2018(CURRENT) INDEX FOR 12/2002 [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE   A    A 

Upper front strut mount/bearing assy; prefernces?

I'm pretty much all Kaplhenke on my street driven 82 242/LS3. I used his castor/camber plates and his "Luxe Steer" strut bearings. All I can tell you is that all that stuff really works nicely together. Koni Sports, Eibach springs (2.5" x 12" x 275 lb/in front; 5" x 14" x 200 lb/in rear), Ben's adjustable perches front/rear; IPD 28mm/22mm sway bars; IPD adjustable Panhard; IPD adjustable upper torque arms; Ben's strut brace and master cylinder brace; poly bushings throughout; reinforced lower rear control arms; Ben's adjustable front sway bar links; Ben's roll center adjusters for the front tie rod connections. It's not inexpensive, but you won't find anything that works better.

 





[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Upper front strut mount/bearing assy; prefernces?
posted by  nortons  on Sun Nov 25 21:48 CST 2018 >

[about brickboard ads]

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts