Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2004

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

The DASTARDLY DEED is DID ....

Ringlee ... just got off the phone with the machine shop .... block will be ready Friday .... bored, with a new set of MAHLE pistons and rings and the crank honed .. all necessary gaskets & bearings.... CDN$1,250 + 15% Tax ...... about twice as much as I was hoping to get away with .... but the motor should be good for a long time to come .... and that was with getting a break on the Mahle pistons ... only $300 as they were OLD stock .... if he had to bring in a new set they would have been over $400 ... this does not include the cost of the STREET TORQUE CAM and LIFTERS or new rear seal that I provided .... This puppy better purr like a kitten when we get her back in the car ...... I also used the time with the engine out to "tiddly up" the engine compartment so I won't be ashamed to lift my hood to the public any longer .... now all I have to do is go see my friendly neighbourhood loan shark to bail her out .... SIGH ..... no wonder I decided not to do a "ROAD TRIP" this summer ....
--
Brett Sutherland & the 1.5 million mile 122 CANADIAN www.ecvintagevolvo.com






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New The DASTARDLY DEED is DID ....
posted by  brettsutherland subscriber  on Wed Jun 30 10:29 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.