[CLASSADS INDEX] [LOG IN] [SIGN UP] [MISC USER TOOLS] [PREFERENCES]
RSS Feed
| 1985-1988 Bosch AMM (3); bushings, distro | |
|---|---|
| POSTED BY | geodonuts<geoff d> [VIEW PROFILE] |
| AD ID | #17451 |
| [LOGIN REQUIRED TO VIEW EMAILS] | |
| CATEGORY | For Sale |
| CLASSIFICATION | Parts |
| MODEL | 200 |
| YEAR | 1986 |
| TRANSMISSION | manual |
| COST | 75.00 |
| CURRENCY | USD |
| SALE CONDITION | BEST OFFER |
| ENTERED | Wed, Feb 12th 2020 at 5:36 AM CST |
| EXPIRES | Thu, Apr 9th 2020 |
| LOCATION | OR [Yahoo Map] |
| VIEWS | 1041 |
| DONATE | |
|
A bundle of:
Three (3) original Bosch Air Mass Meters/MAF sensors from 1985-1988 240s and 740s, Bosch part number 0 280 212 007 printed on the side. Obtained via scrap yards, they were all and bench tested and road tested. Impedance all was as close to spec as any, each showed its burnoff function was working, and I ran my car on a rotation of these for a while. however, that was a few years ago and I no longer own a 240 with which to auger their fate. They were always treated right and have been recently cleaned with MAF-blaster and q-tip before being I moved them to a ziplock bag inside my house, where they seem happy. Next is an incomplete set of rubber bushings for same year and model, 1986 245, bought from IPD in 2009 as part of their suspension kit (believe this to be OEM-equivalent but not sure. IPD part # included). The following: (4) torque rod, F&R, #1273622 (2) panhard rod (frame end[?]), #1330973 (2) trailing rod - front, #1229165 (2) trailing arm (rear end of course), #1229165 An ignition DISTRIBUTOR for same engine year (1986-88, or 85-87?. This would be for a Bosch-ignition year, not Chrysler. I never installed this due to a misdiagnosis of my problem, and I'd like to save someone else the trouble I had to go through just to locate this uncommon part then extracting it. This Aurthurian piece is optional to the bundle, so anyone who simply wants it can take it for free. Also! Comes with an incompletely finished homebrew TAB tool seen somewhat in the picture, bolt and washers missing. Instead of grinding cast iron pipe end I had a friend machine cut a cylinder by lathe to precise dimensions, so it reasons it'll work, however I never used it once I saw that my bushings were actually fine. And the cylinder pusher needs a rest hole reset to one face to accommodate the bushing hub, which hadn't been done by machine, so it's another freebie to those who have the time. The 6" x 0.5" bolt, receiver end and pieces, and 2 inches of washers comes with it (not pictured.) $75 or best offer - really, I'll take anything. Thank you. send private message or email me at geodonuts -at- gmail https://postimg.cc/wRJmpTmv 
https://postimg.cc/ZCS9NmN8 -- closeup of the AMM https://postimg.cc/7f9LT2w4 -- distributer  |
|
It is the buyers' burden to verify each and all details. The information provided by the poster is presumed to be accurate but Brickboard.com has made no effort to verify accuracy. Caveat emptor.
Buyers and sellers are encouraged to use any of the following or similar services: IEscrow.com or www.PayPal.com.