Volvo RWD 140-160 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 11/2000 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Re: Driving shaft clunk 140-160 1967

posted by  someone claiming to be Ignace Speybrouck on  Thu Nov 16 05:51 CST 2000 [RELATED]

Hi Syd,

Well those 3 supports are about 8 months old (2 engine, one trans.) The transmission one hasn't been upgraded, too bad we didn't know each other a bit earlier !

As For the shock absorber, they are also about 8 months old and I did upgrade the 1/2" lower holding studs with the 5/8" ones.

The rear outer bearings and seals have been replaced too. They are grease type. First time I saw something like this. I have an oil seal closer to the diff. , the bearing and a grease seal. Not much loose there. Don't know about the inner ones though. I did change the oil in the diff. two years ago. 80W90 went in.

Also the rear suspension bushings are one year old (IPD).

The noise seems to appear when the angle of the driving shaft changes.

Have to say I'm really puzzled about this one.

Ignace





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Driving shaft clunk [140-160][1967]
posted by  someone claiming to be Ignace Speybrouck  on Wed Nov 15 17:35 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.