Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 2/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: H20 pump 200 1984

posted by  someone claiming to be dave lotman on  Mon Nov 13 08:08 CST 2000 [RELATED]

Well first I would say "what brand of water pump are you installing?"

If it is the affordable GMB pump you may have a very rough finish to the

casting in that area. You should use some grit cloth or sandpaper and finish the surface of the area where the gasket seats. Another thing I use

is a lubricant like Dow 111 to treat the gasket and its sealing surface so

the seal is not going to stick or tear. Make sure when you insert the pipe

into the pump that the seal seats without getting sideways or getting

caught on the metal around the hole. Thats about it really.

Dave 82 242ti





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New H20 pump [200][1984]
posted by  someone claiming to be Hayes Markie  on Mon Nov 13 06:36 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.