Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2011 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Problems Pulling Engine B230T fron tranny 700 1989

posted by  Vrizla on  Wed Jan 21 07:38 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jun 1 23:55 CST 2009
[RELATED]

I'm trying to pull my engine from my 89 760 turbo wagon (automatic). I don't have enough room to pull it with the tranny. I have browsed articles on this board and read instructions from my Haynes manual. Pulled ac compressor, power steering lines All wires hoses & vacuum line have been disconnected as well as distributor engine mounts, starter, engine to transmission bolts flywheel drivepate bottom cover and I unbolted the 4 torque converter to flywheel bolts


I'm lifting it with an engine hoist from the lifting eye and have a chain wrapped underneath to support the back. The engine will not let go from the tranny\torque converter The only thing listed in my Haynes manual that I don't think I removed are what they call "earth straps" Which I have never heard of &don't think I have. If anyone have any ideas I would greatly appreciate it





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Problems Pulling Engine B230T fron tranny [700][1989]
posted by  Vrizla subscriber  on Wed Jan 21 07:38 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.