Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Rear Trailing Arm tool fabrication/use ? 200

posted by  Erling on  Mon Nov 24 19:03 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed May 22 00:57 CST 2013
[RELATED]

Good advice on applying grease on the bolt. For the last two cars I did, I used two large washers at each end of the bolt and smeared lots of grease between the washers, and between nut and washer. Still, each pair of washers show visible wear marks. There's a whole lot of friction.

Pictures here.

Erling.
--





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Rear Trailing Arm tool fabrication/use ? [200]
posted by  transit wind subscriber  on Mon Nov 24 12:22 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.