Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Rear Trailing Arm tool fabrication/use ? 200

posted by  weather on  Mon Nov 24 18:05 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 26 23:16 CST 2012
[RELATED]

you only need to push the bushing about 1 inch. then it will simply slide out. make absolutely sure that the tool is centered on the bushing before you begin pressing.

yes the tool is used to press the bushings back in. it's easier than push out.

word of advice: other than the well known Johnny Chan of Seattle, Washington, do not lend your tool to Ellis "LT" Leo Thompkins of Bowie, Maryland either.

i hope that do-not-lend list doesn't grow longer.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Rear Trailing Arm tool fabrication/use ? [200]
posted by  transit wind subscriber  on Mon Nov 24 12:22 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.