Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Front Oil Seal Questions 200 1988

posted by  planetman on  Sat Dec 8 13:10 CST 2018
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 09:29 CST 2014
[RELATED]

Here's how I do it.

Clean then lightly lubricate the crankshaft seal surface with engine oil.

Pack the back of the seal with grease where the spring resides. This will help keep the spring in place while you are installing the seal. I normally use "SuperLube" which is a thick clear silicone grease and comes in a tube that I buy from my local Ace Hardware store.

Lubricate the lip(s) of the seal with engine oil. I prefer not to use the SuperLube as it has a tendency to cause the seal to make noise.

I can not understand why anyone would lubricate the outer diameter of a seal that needs to be a press fit. Lubing the outside might cause the seal to slip afterwards. I've had to replace the aluminum front covers on OHC Volvos engines due to a slipping auxiliary shaft and front crankshaft seals.

I know of and use a special lubricant for pressing various bushings and bearings that doesn't cause slippage afterwards, but that is for metal to metal surfaces.

--
Eric
Hi Performance Automotive Service (formerly OVO or Old Volvos Only)
Torrance, CA 90502






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Front Oil Seal Questions [200][1988]
posted by  1908242DLa  on Sat Dec 8 09:32 CST 2018 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.