Volvo V8 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2007

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Header clearance

posted by  flyboy on  Sat Feb 12 13:49 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Nov 26 03:47 CST 2013
[RELATED]

Hi Michael,

There is no way you can fit an xpipe on the 240Ford V8 conversion. I tried everything to get this to work and it is not possible. Just get the sledge hammer out and you will fit the Ford Racing headers with no problems. You only have to pound a bit on the passenger side rail and cut the corners on the lower control arm "metal structural bracket that holds the rear control arm bushing"(now there is a mouth full:>)I did this on my car. It will work very well and don't worry about doing any structural damage to the rails as they are built like the proverbial "brick sh*t house". I can remove the headers without raising the engine and I can also replace the exhaust system without taking the tranny out. Also, if you use the "mini" starter it creates a lot more room.
If it is not snowing!! tomorrow I will get some pictures and send them to you of my header and "indentation"

Cheers,






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Header clearance
posted by  Michael Yount  on Fri Feb 11 13:33 CST 2005 >
  • New Header clearance
    posted by  someone claiming to be drfrankenstein  on Fri Feb 11 15:02 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.