Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2024 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Details of the wiring of the fuel pump relay 200 1986

posted by  rjs on  Wed May 28 17:22 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I have been going around with the problems of the fuel pump relay and would like to know how the internal relay (A) actually gets the ground to pull in. The other internal relay (B) has a hard wire ground and gets the +12 from the IGN SW in RUN or START position.
I have looked estensively at the Wiring Diagram in Bentley and still can't find the so called 31b connection.
Is it thru the ignition switching circuit on the low side of the Ignition coil, and the associated pick up unit in the distributor?

This might be too long to post, so I'd like to hear via email is that's better.
rjstulsa@aol.com
Thanks Bob






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Details of the wiring of the fuel pump relay [200][1986]
posted by  rjs  on Wed May 28 17:22 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.