Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2023

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Hole tapping question

posted by  Don Foster on  Fri May 31 00:16 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Oct 5 11:53 CST 2014
[RELATED]

"...happened to 5ave this 1/4"-20 tap..."

Sounds like it's time to run a 1/4" clearance bit through everything, use a nut 'n bolt, button it up, drive it. At this point, I'd install the pan minus the missing bolt -- and once in place, run the drill through everything. Use a lockwasher or double-nut it.

"...how is teaching going?"

Very well, thanks. Grades submitted Tuesday. This was an unusual semester -- 2 F's, 1 C, and 15 A's (A-, A, A+). I tried a new approach to teaching eng'g students, and it seemed to work.
--
Don Foster (near Cape Cod, MA)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Hole tapping question
posted by  Zee subscriber  on Wed May 29 20:40 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.