Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 11/2000 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: distributor shaft alignment 200 88

posted by  someone claiming to be Walter on  Fri Nov 17 12:24 CST 2000 [RELATED]

My concern is not with the rotor being positioned at #1 cylinder top dead center, but rather with the ring under the rotor that has cutouts that pass by the "Hall sender" that sends a signal to the Ignition control module.

This has been referred to in the past by Abe as the shutter wheel.It had to be pressed off the distributor shaft in order to replace the impulse sender

or "Hall sender" Now there is no index to put it back on relative to the

rotor. The Bentley manual shows a type that has snap rings and an index pin, but mine has splines with no reference pins or mark! Help!!





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New distributor shaft alignment [200][88]
posted by  someone claiming to be Walter  on Fri Nov 17 06:12 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.