The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: distributor shaft alignment 200 88

posted by  someone claiming to be Walter on  Fri Nov 17 12:24 CST 2000 [RELATED]

My concern is not with the rotor being positioned at #1 cylinder top dead center, but rather with the ring under the rotor that has cutouts that pass by the "Hall sender" that sends a signal to the Ignition control module.

This has been referred to in the past by Abe as the shutter wheel.It had to be pressed off the distributor shaft in order to replace the impulse sender

or "Hall sender" Now there is no index to put it back on relative to the

rotor. The Bentley manual shows a type that has snap rings and an index pin, but mine has splines with no reference pins or mark! Help!!





USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.