Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2019 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Pulls to the left when breaking 900

posted by  Metallo on  Sun Feb 23 14:26 CST 2025
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Feb 29 21:03 CST 2012
[RELATED]

Hi Dave,

The bushings at the end of the control arm stay, especially the ones on the driver side are gone.

I have ordered 4 new ones and I hope to be able to replace them in a couple of weeks, waiting for the spring.

I also bought 2 bushings of the control arm stay, just in case the existing ones are bad.

My question to you is related to the torque specs, in the pocket book I read this:

1) Control arm stay - control arm Nm 105 or ft.lb 74
2) Control arm stay - Body, M14 Nm 120 or ft.lb 89

Now,is 1) meant to be the M12 that screws in the control arm stay and the 2) the M14 bolt that attaches the control arm stay to the frame? I understand the latter has to be tighten at full suspension load, right?

Thank you!
Alex






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Pulls to the left when breaking [900]
posted by  Metallo  on Sat Dec 21 09:37 CST 2024 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.