Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 7/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

photos of caliper disassembled 200

posted by  trichard on  Fri Nov 20 11:31 CST 2015
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 05:52 CST 2014
[RELATED]

hi art

the initial hole between each bore hole is at a 45 a bit less than 1/2" diameter. then a smaller more like 3/16 is drilled at a shallower angle where it intersects with the one drilled from the other side.

all in all fluid deposited into one bore hole flows instantly into the other

i am reluctant to remove the set screws especially the tiny ones for fear i might ruin the threads. there does appear to be some sort of material inserted into the bleed hole then the set screws are threaded in. this might be something as simple as gasket maker in a tube.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 2 has anyone else ever seen this on a caliper [200]
posted by  trichard  on Thu Nov 19 11:22 CST 2015 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.