Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2004 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Engine Stalls; Error Codes Pulled 900 1994

posted by  Greg R on  Thu Oct 29 14:03 CST 2015
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Feb 11 23:24 CST 2014
[RELATED]

Hi all,

My son was driving our '94 945 (150K mi) home when he had a loss of power and stalling. I went and checked it; it is able to crawl along at idle but when you gently try to accelerate, the engine stumbles (doesn't stall if you lift foot off the gas in time). Luckily we were close enough to crawl home.

Check Engine light is also on, so I pulled codes.

Test mode 1, Socket 2: 1-2-1 and 3-2-2. (Faulty signal to/from AMM; AMM wire burn-off signal absent or faulty.

I am pretty sure I have the LH2.4 fuel injection, so I'm not sure I should have even pulled codes from Socket 6. I checked for codes anyway and got these:

Socket 6: 2-2-4 and 2-1-4. (RPM sensor intermittent; ECT sensor faulty).

Any advice on next steps? If bad AMM I will set out to check the cable and connection, although I don't know where it is.

Thanks.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Engine Stalls; Error Codes Pulled [900][1994]
posted by  Greg R  on Thu Oct 29 14:03 CST 2015 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.