Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Has anyone ever successfully had their alignment done properly? 200

posted by  Rhys on  Wed May 9 23:13 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Nov 20 10:22 CST 2012
[RELATED]

Camber and caster units are normally degrees - my advice is to go with the caster you've chosen (considered non-adjustable on the 240 and that will be what the manual will tell the technician) and to go with zero camber, or slightly negative camber, -.25 if they can do that.
The toe-in is normally in inches, and a negative value means toe-out. If that number is in inches, then .12 is nearly 1/8 of an inch, which is too much. 1/16 of an inch, or .065 inch, would be better.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Has anyone ever successfully had their alignment done properly? [200]
posted by  transit wind subscriber  on Wed May 9 18:54 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.