Volvo RWD S90-V90 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2003 S90-V90 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Drilling a Hole in Oil Cap or Re-Routing Excess Gasses S90-V90 1998

Hi!

I replaced the PCV system (flame trap and oil box) and associated hoses, but my car continues to fail the glove test. I was thinking: could I just drill a hole in the oil cap to relieve excess pressure? Maybe have it route to a catch can? Alternatively, could I take maybe the breather hose off the flame trap and route it to a catch can?

I don’t have the energy to take the whole intake manifold off again, nor do I want to check every single vacuum hose. Just thought this might help alleviate pressure - especially since my front cam seals are blown and I’d like to get rid of excess pressure before replacing them. I don’t have to worry about an inspection from the local authorities. So, that’s not a problem.

Any thoughts?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Drilling a Hole in Oil Cap or Re-Routing Excess Gasses [S90-V90][1998]
posted by  HerrGruyere  on Mon Jul 8 11:26 CST 2019 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.