Quantcast
RWD - Looking for wiring connectors for 1800ES turn signals

Volvo RWD 1800 Forum

INDEX FOR 7/2019(CURRENT) INDEX FOR 2/2004 1800 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

Looking for wiring connectors for 1800ES turn signals 1800

I am repairing the wiring to the lights on my '54 Chevy by running a new soldered wire to a spot where I can fetch them.

Then I install female un-insulated spade connectors, crimped and soldered to both wires.

I join them with a clear plastic encased double male spade connector.

That way I can check the bulb without taking the fixture apart and I can see any corrosion.

These connectors were used in my '68 VW - they even make two to one connectors.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Looking for wiring connectors for 1800ES turn signals [1800]
posted by  fran krause  on Fri Feb 22 12:39 CST 2019 >

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts