Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Wires from exterior drivers side door lock question 200 1986

posted by  Xraybob on  Tue Nov 25 06:27 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 05:32 CST 2014
[RELATED]

This past weekend I replaced both DS & PS front door handles. I lubed up everything while I was in there and now all is good as new. I noticed that on the drivers side key lock looking from the inside, there are about 3 wires attached to the tumbler assy that are starting to look as frayed as my main wiring did before I replaced the gray harness junction on the firewall. I'm afraid that these wires insulation will rot away entirely and short out or the locks switch will fail completly. Any suggestions or repairs that can be made before problems arise? I didn't know there were any wires attached to this part.

Thanks for looking.
--
'86 sedan with 400,000 miles on the original engine and automatic transmission






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 Wires from exterior drivers side door lock question [200][1986]
posted by  Xraybob  on Tue Nov 25 06:27 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.