Volvo AWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2023

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Changing out the screw will not work

posted by  riverbend on  Sat Jun 11 15:13 CST 2016
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 15:29 CST 2014
[RELATED]

I think you are supposed to pull the motor out to get to that one...

An 8mm head indicates a 5mm thread, ~0.2". Does that sound right ?

There is a fine thread option, but in aluminum they should have used a coarse thread, so the pitch should be 0.8mm. You can eyeball it against a ruler. The fine pitch is 0.5mm.

The drill size for an M5 helicoil is 5.2mm (or 13/64"). The amount of material to remove is 0.004" (hole size increases by 8 thou.). The drill will follow the existing hole once it gets started, so no need for a level. I would be tempted to try screwing the drill in by hand with a pin vice or some other sort of collet to get a grip on it.

I don't have any inserts that small.

Greg





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Using loctite on a stripped screw
posted by  KlausC subscriber  on Thu Jun 9 11:23 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.