Volvo AWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2020

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Using loctite on a stripped screw

posted by  KlausC on  Fri Jun 10 09:45 CST 2016
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:15 CST 2014
[RELATED]

"Out of the box - you could take an extra screw, cut its head off and epoxy it upside down in the hole, making it into a stud - put a nut on the threaded top. "

I like your thinking! All I need to do now is find an extra screw. I wonder how much torque could be handled with the epoxy and the polished screw end?

Did I mention that the engine runs quite well with just 2 screws?
--
Keeping it running is better than buying new






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Using loctite on a stripped screw
posted by  KlausC subscriber  on Thu Jun 9 11:23 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.