Volvo AWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2022

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Using a small piece of copper sheet/piece

posted by  Chris Mullet on  Thu Jun 9 14:49 CST 2016
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 09:08 CST 2014
[RELATED]

Or roll up a small piece of aluminum foil - not too many wraps - and drop it in the hole. Then screw the screw into it. Make sure all of the old stripped-out aluminum is cleaned out of the screw threads before screwing it down into the foil-lined hole. The foil should be soft enough for the screw to dig new threads into it.

Another option is to drill and tap the hole out to the next screw size, but I think that would be more of a last resort.
--
Current rides: 2005 Volvo S80 2.5T, 2003 Volvo V70 2.4NA, 1973 Volvo 1800ES (getting ever closer to road worthiness)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Using loctite on a stripped screw
posted by  KlausC subscriber  on Thu Jun 9 11:23 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.