Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2002 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

How hard it is to replace a fuel injector ? 850 1997

posted by  Dennis 850GLT on  Mon Jan 8 01:32 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Aug 13 08:42 CST 2011
[RELATED]

Hi there, thanks for the info.

I've swapped the injectors of cylinder #1 with the one of cylinder #2 and like you've recommended, I've replaced all "O" rings and seals for all injectors: no success, cylinder #1 still dead. So, it's not the injector.

I checked the compression on all cylinders: 180 psi (+/- 3 psi average). I also checked the voltage at the injector plug with a LED probe (light-emitting diode in series with a resistor) the results are identical on all injector plugs. Of course, I did 2 weeks ago a complete tune-up: plugs, ignition wires, rotor, distributor cap, fuel filter, air filter, all vacuum elbows (a couple of them were slightly rotten: I've replaced them all) but no changes, I'm still stuck with the same problem.

Any ideas?
--
Dennis






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How hard it is to replace a fuel injector ? [850][1997]
posted by  Dennis 850GLT  on Thu Jan 4 10:37 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.