The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

242 Turbo/DL differences? Make 1 good car from 2?

I am restoring a "83 242 Turbo. The car is very rusty and due to the scarcity and high cost of 2 door body parts, I bought a super clean '84 242DL from Arkansas to use as a donor for the Turbo. The '84DL is a total "stripper", a base car with no sunroof, no A/C, no power anything, basic shabby cloth interior, etc, but has a super nice, virtually rust free body. Plan was to cut up the DL as needed. I now realize it would be much better to use the Turbo as a donor for the DL, swapping out A/C, suspension, sunroof roof panels, etc to the DL and start with a much nicer, more solid body for a rotisserie restoration. Once the Turbo started coming apart, the extent of the rust was much, much worse than thought. The Turbo has a lot of sentimental value to me, it's the car I had when my wife and I were dating, (the stories that car could tell!), but I think it just might be too far gone. The 70,000 tons of salt used in an average winter here in metro Detroit have taken their toll.
The car will have a Ford Mustang 5.0V8 engine/5 speed manual trans. driveline. I have some of these parts already.
My questions to the collected knowledge on this forum are;
I know struts, springs, etc are different on the Turbo. Will this all swap over from the Turbo to the DL? Are there additional reinforcements, gussets, body stiffeners? Welded in? Basic body shell is the same? What about rear axle assy? Steering? Is there a parts list available? DL is automatic, Turbo manual trans. Will be using manual trans with v8, will clutch pedal assy swap over to DL simply?
The Turbo was in running condition when parked. Wiring harness, etc, in good condition, power windows, mirrors, even a/C was working. All of this LOOKS like it should swap over. What am I not seeing?
This is going to be a serious resto-mod with big brakes, 300+hp, and my friend owns a trim shop for the interior. I know this is gonna be expensive, I'm prepared.
With a complete manual trans turbo car at hand, I should have a lot of the little bits that are hard to find, but there is always a "Catch 22" (The "catch" is there is always a "catch")
Any tips/experience/advice/horror stories, etc, will be greatly appreciated.






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.