Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 11/2000 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Setting the AMM ???????/LH.2.2 200 1988

posted by  david hunter on  Sun May 1 12:18 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jun 30 22:10 CST 2014
[RELATED]

You must turn the screw on the AMM back and forth until the lights starts to flash. Then tweak it some more for equal time off and on, this fine tunes the mixture. It is normal to see the voltage swings on the O2 sensor output even though the test point light is not flahing. If the amm is so far out you will not even see the O2 voltage swings. If the light goes off when you rev it it sounds as if you are close. Keep track of your turns as you turn the screw.
BTW a normal analog meter will do the same as the light.
--
David Hunter






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Setting the AMM ???????/LH.2.2 [200][1988]
posted by  rsjones  on Sat Apr 30 12:39 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.