Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 9/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Another problem with the reverse detent sleeve. 200 1983

posted by  smith_t240 on  Tue Apr 5 17:55 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Apr 24 02:21 CST 2007
[RELATED]

You're saying its hard to pull up the reverse detent lever because the wires are in the way???

Because that is what happened to me when I pulled the tranny on my beater. The thing is, I really didn't care about how the hell it went back together, but I can see your concern. The reason it did that is because the wires aren't straight in the shift lever, there's slack so they kinda bend over and don't leave room for the lever to slide up to get into reverse.

Not positive, but a good thing to try and do is look where the wires enter into the stickshift, and pull them out to the point where they stil make contact with the overdrive button, but no more, that way they're not in the way.

I think the wires enter about halfway down into the shifter.

Post back with questions,

Smith






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Another problem with the reverse detent sleeve. [200][1983]
posted by  Mr brick driver  on Tue Apr 5 16:34 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.