Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2024

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Flatten Head...

posted by  someone claiming to be Al A. on  Fri Oct 29 15:31 CST 2004 [RELATED]

We've done something similar to flatten the warp in carburetor castings...a sheet of emery cloth on top of glass, kept wetted with kerosene, and the carburetor parts slid in a circular motion until there was a nice, even contact all around the surface. I've never tried this with a cylinder head. I hope it works well for you.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Flatten Head...
posted by  FuguFusu-Inc  on Fri Oct 29 05:57 CST 2004 >
  • New Flatten Head...
    posted by  someone claiming to be Al A.  on Fri Oct 29 15:31 CST 2004 >
  • New Flatten Head...
    posted by  Gregg Shadduck subscriber  on Sat Oct 30 01:13 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.