Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2007

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

960 transmission question

posted by  M on  Tue Oct 5 10:32 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat May 1 10:12 CST 2010
[RELATED]

If the PNP switch was replaced only a week before, I'd suspect the mentioned connectors on the trans left side. They were separated when the PNP was replaced and something might have gone wrong with the pin (green wire) related to solenoid S1. Grey connectors made in brittle plastic - be careful when you separate them and check carefully for pins not fully in level with the others. Clean all pins out and use contact grease when reassembling.

Martin
--
'65 121, '73 165






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 960 transmission question
posted by  rparker996@MSN.COM  on Mon Oct 4 03:23 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.