Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2019 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Tips for heater control valve replacement? 900 1993

posted by  spook on  Wed May 12 16:08 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 08:06 CST 2014
[RELATED]

Dear Fellow Brickboarders,

May this find you well. It is standard practice, to install the heater control valve into its hoses, and then install this assembly? Or, does the hose have to be attached to the tube from the water pump, the heater valve then inserted into the hose, and the hose then run from the control valve to the firewall nipple?

The return line is obviously a straight run, so the hose must be threaded through the maze, until it reaches the port on the side of the intake manifold.

Thanks for any light you can shed on this.

Yours faithfully,

spook






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Tips for heater control valve replacement? [900][1993]
posted by  benfingland  on Wed May 12 03:13 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.