Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2006 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

CAMBER OR DAMAGE 700 1987

posted by  someone claiming to be rcsammy on  Mon Dec 22 18:01 CST 2003 [RELATED]

The spindles are different, the hubs and the bearings are different.You cannot use pre '88 hubs on post '88 spindles and vice-versa. The rotors MAY be the same, lots of different brake combos were put on these cars. Right confusing to say the least. Any 1987 and earlier strut tube/spindle assy. should work. Easy way to check which type bearing/hub is in car, remove dust cap from front hub,see if there is a cotter pin in the spindle nut. If you have cotter pin your car has early hubs/bearings. No cotter pin means that they have been switched to '88 and up hubs/bearings. Hope this helps.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New CAMBER OR DAMAGE [700][1987]
posted by  VOLJO  on Sun Dec 21 20:07 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.