Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2013

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

replacing Voltage regulator brushes

posted by  runwld2 on  Mon Oct 20 03:47 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Sep 30 13:11 CST 2014
[RELATED]

In trying to replace the brushes on my Bosch regulator I cannot get off the old ones. One style of regulator has the brush wires come up and bend over to terminals beside the brush block. Others have the brush wires straight up and crimped and soldered atop the block. I have done the former type, but the latter I cannot get the brusheds to release after heating the solder joints. Even resorted to a torch on a non working VR. They must be crimpted AND soldered? What is the trick?
Also to ease removal of VR assy from back of alternator, am replacing phillips head screws with hex head bolts. Never enough room to get the screw driver in there, bolts should be easier.......
--
744-16v,745-16v,242Turbo.245DLT






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New replacing Voltage regulator brushes
posted by  runwld2 subscriber  on Mon Oct 20 03:47 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.