Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Manual setting of mixture screw on K-jetronic system 200 1980

posted by  edmartz on  Fri Sep 12 18:14 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Jul 21 17:04 CST 2009
[RELATED]

I have this same problem, and was one temperature sensor, your brick have a frecuency valve?, its buzzing? if yes... with the motor off, disconnect this and check if works... Actually I have my brick with out this frecuency valve connected and runs well (not that I want, but I have to change this sensor)

hope this help you...


Edwin






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Manual setting of mixture screw on K-jetronic system [200][1980]
posted by  mikeH2  on Thu Sep 11 12:47 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.