Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2013 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Need help: Polishing and Buffing paint (removing swirls/oxidation) 200 1987

posted by  corky310 on  Wed Aug 20 11:00 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Ok, the one thing that I'm good at-
I have been detailing cars for the last 20+ years and have always found the Meguiars products superior to the 3M. Since it sounds as though you have all of the silver paint off and are left with swirl marks, I would go to a #3 Meguiars glaze. Apply with an ORBITAL buffer and NOT a power buffer. Go over it several times if you have to, going in different directions each time. Run the buffer over the surface at about an inch every 2 seconds or so and make sure that you wipe off the dried glaze after each application. Finish with an application of your favorite wax. Use a carnuba wax without a cleaner, swirl mark, or oxidation remover. Just straight wax. If you have any further questions, just email me.

c.martin50@gte.net






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Need help: Polishing and Buffing paint (removing swirls/oxidation) [200][1987]
posted by  FitzFitzgerald  on Tue Aug 19 21:15 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.