Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Oxy Sensor fault code 200 1989

posted by  Arthur on  Sat Feb 8 04:13 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Aug 2 07:35 CST 2014
[RELATED]

Last month I replaced the oem heated O2 sensor with a Bosch universal unheated (single wire) one. After 220,000 km and with pollution check coming up I figured I owed the car something.

It worked fine for a month, but last two weeks I was out of town with a failed thermostat during the cold weather I put about 1000 km with the temp gauge barely above the bottom line. finally fixed the thermostat last week, now I get a check engine light with code 2-1-2 (Signal missing/faulty from oxygen sensor). Reset the codes three times, it keeps coming back after about 1/2 hr driving.

Are these two related? I did go a month with no error.

The FAQ says this code is caused by "Wiring fault to heated O2S sensor", but I won't check the wiring until late this afternoon.

The car drives just fine, but I dont want to go to pollution check with check engine light on.

Any advice?

240 wagon, 355,000 km






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Oxy Sensor fault code [200][1989]
posted by  Arthur  on Sat Feb 8 04:13 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.