Volvo RWD 700 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 1/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: Help me find a LSD! 700 90

Nick,

Just Check with a local rear end shop. I went to my local shop in Corvallis (50k people) and they had a used Dana 30 LSD that they had just put new clutches into. They charged me $150 for the part. I then had them install it with new bearings, seals, Speedo pickup, and a new ratio for the rear. (V-8 Mod) Total cost was ~$900. It was on the high side for labor, but they have a good reputation and worked with me so I could send out the rear housing for powdercoating and a few other mods.

Good luck!

-simon

simon_dodd@hp.com

PS, I was doing a 1031 rear housing. This has a larger ring/pinion gear. The volvo Pinion bearing size is "unique" so Volvo (or SAM) is the only place you can buy a new gear set. I opted for a good low mileage set out of an old 240 to get the right ratio.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Help me find a LSD! [700][90]
posted by  someone claiming to be Nick Choy  on Mon Apr 30 08:04 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.