Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 11/2000 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Re: Cleaned Flame Trap - Still Jiggling? 200 1992

posted by  someone claiming to be Don Foster on  Sun Dec 3 08:24 CST 2000 [RELATED]

Just hold your finger over the end (the end going to the flame trap assy.) to sense for vacuum at idle. It should suck. If not, check the hose for blockage, and then the brass fitting.

Be sure the plastic nipple on the trap assembly is clear.

You can usually clear the fitting with a chunka coathanger wire or little screwdriver or drill bit. The hose costs a quarter.



Don Foster (near Cape Cod, MA)





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Cleaned Flame Trap - Still Jiggling? [200][1992]
posted by  someone claiming to be Tom  on Sat Dec 2 15:49 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.