Volvo RWD 120-130 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 11/2000 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Re: floor panels 120-130 68

posted by  someone claiming to be George Downs on  Mon Nov 20 03:23 CST 2000 [RELATED]

Floor panels:

Measure up the sizes you need and go to your friendly local

sheetmetal shop. Get 16 or 18 gauge black iron.

Look out for brake and fuel lines while you are welding.

It is exciting enough without burning or melting them.

I used acetylene but a lot of guys are going to MIG wire

welders these days. You'll probably need to do a lot of

hammering and fitting to get it to look right.

Nearly all my experience with rubber OEM floormats has been

BAD, especially from the durability standpoint. They don't

even last in storage! Also anything that traps leaked water and

holds it against the floor is NOT your friend!





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New floor panels [120-130][68]
posted by  someone claiming to be scott martini  on Sun Nov 19 15:36 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.