Volvo RWD 700 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 2/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Re: High Idle After TB Cleaning 700 1986

I didn't move the TPS at all when removing the TB. I just disconnected it from the wiring harness. All hoses are fine. I had just replaced the engine wiring harness with a new one a few weeks back and it ran fine. I'm sure there's no problem with the connectors since they're new. I did the spray test for vacuum leaks with carb cleaner but didn't find anything. At this point I'm leaning towards replacing TB gasket with a new one and perhaps the O-ring seal within the adjustment screw.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New High Idle After TB Cleaning [700][1986]
posted by  someone claiming to be Paul  on Sun Nov 12 06:27 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.