Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Under dash padding - drivers side - how it mounts? 200 1990

The screws in your picture look like (3) below, if they are M6 tapping machine screws. There are six like those that as a minimum must come out to separate the dash from the framework.



Unfortunately, there are more of those screws bolting the framework together that don't necessarily need to be removed to do the project you did, so if you look at the "7 screws" identified in this page, you might not see any empty spots:

Dash Held in by 7 Screws
--
Art Benstein near Baltimore






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Under dash padding - drivers side - how it mounts? [200]
posted by  Broos  on Sun Feb 12 18:23 CST 2023 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.