Volvo RWD 1800 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2021 1800 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Under Dash Wire Harness Routing 1800 1973

posted by  Chris Mullet on  Sun Mar 11 11:41 CST 2018
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 09:08 CST 2014
[RELATED]

"...Unfortunately the harness is routed directly behind the gauges.

I usually remove the tachometer to access the voltage stabilizer and/or the 2 temperature gauges..."


Ugh! That's what I was afraid of. I got the stabilizer in and connected. Then I installed and connected the upper temp gauge. But then I installed the tach next, before the lower temp gauge. I'll try removing the tach in order to get the lower temp gauge in and fastened. It appears to me that the lower temp gauge will be pressing firmly up against the wire bundle. We'll see how it goes.

I'm tempted to disconnect the illumination (red wire) daisy chain from the rheostat and get it out of the way until all the gauges are in. It's kinda adding to the rats nest.

Thanks!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Under Dash Wire Harness Routing [1800][1973]
posted by  Chris Mullet subscriber  on Sat Mar 10 21:52 CST 2018 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.