Quantcast
RWD - Under Dash Wire Harness Routing

Volvo RWD 1800 Forum

INDEX FOR 12/2018(CURRENT) INDEX FOR 9/2007 1800 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

Under Dash Wire Harness Routing 1800 1973

1973 1800ES:

I hope this makes sense....

After reinstalling the dash I'm attaching the wiring and re-installing/connecting the gauges.The dash was disassembled for WAY too long and, even though I know where all of the wires terminate, I can't recall exactly how the wiring routes to get there. The main part in question is the largest of the wire bundles that comes up from the fuse panel and then runs behind the dash, left-to-right, feeding gauges and switches along the way. I currently have that large harness held up to the bottom side of the dash above the fuse panel, with a harness clamp, per original configuration. Moving to the right from there, i have the bundle wedged between the backs of the tach/temp gauges/speedo and the steering column support. That runs it against the smooth side of the column support but makes things very crowded and difficult to connect the temp gauges in particular.

Should that large harness run across the FORWARD side of the column support?

Anyone have any photos that might help?

Thanks.

 





[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Under Dash Wire Harness Routing [1800][1973]
posted by  Chris Mullet  on Sat Mar 10 21:52 CST 2018 >

[about brickboard ads]

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts