Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

help with bulb failure sensor 200 1998

posted by  twilliams1223@gmail.com on  Fri Jun 28 16:25 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Apr 19 13:00 CST 2014
[RELATED]

Thanks for all the help with this. its driving me nuts. i thought the darn printed circuit board on my 244 was bad

It also sounds like one wire withing the Hinge Harness might be broken

wouldn't all the lights on one side be out. or does one wire power breaks, one running lights and the third the numberplate.



At the Bulb out sensor,with teh Original Sensor plugged in, check 54R and 54L and see if you are getting 12V when stepping on the Brake. these numbers are marked on the Sensor

Hadn't tried this. will do



First check that the RR stop light is working by hooking up another another wire in the vicinity to it. (Your old relay may be fine.)

I didn't know the relays were so expensive. PickNPulls probably offer better value.

will try this. PNP with a 240 is 2 hr away in Winston Salem, NC






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New help with bulb failure sensor [200][1998]
posted by  twilliams1223@gmail.com  on Thu Jun 27 16:41 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.