Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2006 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Engine assembly, tips? 120-130

posted by  planetman on  Mon Nov 8 15:38 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 09:29 CST 2014
[RELATED]

Hello,

I have never found the correct size of square male socket to remove the original oil galley plugs.

I usually have to drill them and use an extractor.

For this particular job I do not like to use an Easy Out.

I have a set of similar tools I bought from Snap On, but their have more flutes to grab the inside of the drilled hole.

Last week, I was dismantling a B16 for rebuilding and I needed to remove the forward oil galley plug and on a lark I tried one of the smaller Irwin brand extractors from a set I bought from Kragen that is advertised to remove stripped nuts and bolts.

I pounded it on and it actually got a good enough bite on the outside of the protruding section of the oil galley plug and it pulled it right out.
--
Eric
Hi Performance Automotive Service (formerly OVO or Old Volvos Only)
Torrance, CA 90502






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Engine assembly, tips? [120-130]
posted by  nictalope subscriber  on Sat Nov 6 11:41 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.